DGW Release Notes v45.1.1870

Added support for the new Voice Quality Estimation (eMOS) Licence enabling the new Estimated MOS feature.

Vm service now supports the factory-installed Vm feature. A factory reset will delete all vm images under vm/images and will create a new snapshot from the factory-installed Vm.

The limit of "Other" certificates that can be present on a unit has been increased to 20.

IN-14230

The following parameters no longer have an impact on incoming ISDN calls:

• Isdn.PrimaryRateInterfaceInterop.UseImplicitInbandInfoEnable
• Isdn.BasicRateInterfaceInterop.UseImplicitInbandInfoEnable

Vm service now supports factory-installed Vm feature. A factory reset will delete all vm image under vm/images and will create a new snapshot from the factory-installed Vm.

"Other" certificate limit has been increased to 20.

IN-14405

Documentation was updated with the missing information:

• An example using the Pause command is now provided in the Configuration Scripting Language document.
• A description of the Pause command is now provided at the beginning of the Reference Guide.

The %profile% macro is now supported properly in the Generic File Name" and "Specific File Name" of the configuration scripts and in the EMS configuration scripts.

RTCP statistics no longer become inconsistent under bad network conditions for SRTP calls being put on hold.

The recovery mechanism that sets the TelIf service to manual start when DGW stops responding did not work when the unit was restarted after the factory reset. This problem has been solved no longer causing units to become RMAs.

Adding participants to a large conference fails because SIP REFER does not respond to challenges. As the SIP REFER can now be challenged, it is now possible to add participants to a large conference calls

The DGW firmware is no longer rebooted during a unit factory reset.

IN-13829     

When a file is uploaded with Internet Explorer, the path is now removed from the file name.

IN-13829

A file name containing slash/backslash can now be deleted through the DGW Web page under Management/File.

IN-14255, IN-14289, IN-14246

In the "SBC/Events" DGW Web page, the "Notice" event type is now included in the "Type" filter selection list.

IN-14249

The Conf Service unlock mechanism now works as expected with concurrent accesses.

IN-14231

If the SIP call is set on hold during the transmission of rtp-event packets (e.g. DTMF), when the call resumes (unhold), the DTMF tone remains on the SIP side. The DTMF tone is now used correctly when holding/unholding a SIP call.

IN-14230

The UseImplicitInbandInfoEnable parameter had an unwanted effect on ISDN to SIP call.  Now only the SIP to ISDN calls are affected by the UseImplicitInbandInfoEnable parameter.

If the ISDN UseImplicitInbandInfoEnable interop parameter is set to disable, the ringback tone is now correctly locally generated towards the SIP peer.

IN-14081

In a rare condition , the SIP Gateway status gets stuck in the « Restarting State » . This caused the SipEp service being unable to restart. The condition preventing the restart was fixed.

IN-13134

After an attended call transfer failure, the transferor is now able to retrieve the call.

When help information for some commands is displayed in the CLI, if more than 2 consecutive parameters are enum, the information is not properly and completely displayed. The CLI help now displays all command help information properly.