Available DGW Firmware Versions

Latest DGW Version

Previous DGW Version

Skip to end of metadata
Go to start of metadata

Download PDF Document



2020-09-15
46.2.2239
Top

1 New Functionalities

Incident # CR # Synopsis Applies To
Description

DGW-13403 Add CRout service parameters to the TR-069 datamodel. TR-069

The following parameters from the CRout service were added as "Mediatrix Specific Parameters" to the TR-069 datamodel.

Tables:

  • AutoRouting
  • Route
  • MappingType
  • MappingExpression
  • Hunt
  • SignalingProperties
  • SipHeadersTranslation
  • CallPropertiesTranslation
  • SipRedirect

Scalars:

  • AutoRoutingCriteriaType
  • AutoRoutingEnable
  • AutoRoutingIncomingMappings
  • AutoRoutingIncomingSignalingProperties
  • AutoRoutingOutgoingMappings
  • AutoRoutingOutgoingSignalingProperties

DGW-13349 Add the FXO, E1T1, and BRI lines to the TR-104 VoiceProfile.Line table. Cwmp

Only the FXS line was present in the TR-104 VoiceProfile.Line table. The FXO, E1T1, and BRI line are now also present in the TR-104 VoiceProfile.Line table. The lines are listed in the following order:

  • FXS
  • FXO
  • E1T1
  • BRI

DGW-13256 Add the support of the rtcp-mux attribute. Sbc

The Sbc service can now be configured to insert the 'rtcp-mux' attribute when sending an SDP offer.

IN-14651

DGW-13233 The Sbc service relays a Hold Request/Response with the Connection Address set to 0.0.0.0. Sbc

The new Rectify SDP content action can be added to the Call Agent ruleset. Under this action, the Hold IP Connection Address parameter fixes an SDP that contains a connection address set to the Hold IP address. This parameter will only work if the "Enabled RTP Anchoring" action is also used.

DGW-13140 The SIP OPTIONS request sent by the Sbc service must contain a Contact header. Sbc

The SIP OPTIONS request sent by the Sbc service now contains a Contact header.

DGW-13097 When Stun is enabled for Cwmp, the UDPConnectionRequestAddress and NatDetected parameters must send notifications by default. Cwmp

The TR-111 Device.ManagementServer.UDPConnectionRequestAddress and Device.ManagementServer.NatDetected parameters now have an "Active" notification level by default. For more details, refer to the https://documentation.media5corp.com/display/DGWLATEST/TR-069+Mediatrix+DataModel.

DGW-12814 The Sbc service relays a Hold Response with the 'a=sendrecv" attribute. all

The new Rectify SDP content configurable action can be added to a Call Agent ruleset. Under this action, the Handle missing stream direction parameter fixes an incoming SDP answer that does not contain a stream direction attribute.

DGW-12761 Allow the use of a public FQDN, not just an IP address, for the signaling and media interfaces. Sbc

It is now possible to enter an FQDN in the SignalingInterface.PublicIpAddr and MediaInterface.PublicIpAddr parameters. The FQDN is also available via the status of the SignalingInterface.PublicIpAddr and MediaInterface.PublicIpAddr parameters.

DGW-11475 Add the new Australia3 country compliant with the Australian AS/CA S002 and S003 standards. FXO

The Australia3 country value has been added to the TelIf.CountrySelection parameter.

This new country value is required to comply with the Australian AS/CA S002 and S003 standards. FXO ports now meet the Voice Only transmission requirements derived from the harmonised European/North American requirements for IP-based telephony.

Top

2 Modified Features, Functionalities, and Interface Modifications

Incident # CR # Synopsis Applies To
Description
Top

3 Issues Fixed

Incident # CR # Synopsis Applies To
Description

IN-14749

DGW-13384 The DSP card READY LED is set to OFF even when the DSP card is detected. DSP card, Sentinel 400

The READY LED of the DSP card was previously set to OFF and now it set to steady AMBER when the DSP card is detected. During a LED pattern, the LED will follow the LED pattern and it will go back to steady AMBER thereafter.

DGW-13355 Mixing end-point and trunk gateways does not display an error message to the user. all

When a mix of both end-point and trunk gateways is present on the unit, a warning is now displayed to the user: "Unsupported configuration: Do not mix Trunk and Endpoint gateway types".

IN-14734     

DGW-13289 Error message displayed when executing a Gateway_Configuration.cfg. all

Executing a Gateway_Config.cfg configuration no longer causes an error message.

IN-14778

DGW-13287 On an S724, VMWI does not work on port 24. S7

Visual Message Waiting Indicator (VMWI) now works on port 24 of the S724.

DGW-13286 Cannot create two signaling interfaces with TLS only on the same network in the Sbc service. Sbc

The Sbc service now allows creating two (or more) signaling interfaces with TLS only on the same network.

DGW-13281 Using PCM Capture while losing network access could result in an unresponsive device. all

Losing network access while using PCM Capture will no longer result in an unresponsive device.

DGW-13229 Packet Capture produces capture files with invalid Ethernet headers when capturing on eth2-5. S400, S100, G7, S7

The Packet Capture tool now produces capture files with valid Ethernet headers.

IN-14683

DGW-12970 The Sbc service shows a wrong Registration Agent Subscriber status after receiving a positive SIP registration response without the 'expires' parameter in the Contact header. Sbc

The status of the subscribers of the Registration Agent is now correctly set.

IN-14687

DGW-12777 The "415 Unsupported Media Type" SIP message is not sent after receiving an SDP offer without any compatible codecs. all

The SDP offer is now immediately rejected with the "415 Unsupported Media Type" SIP message if none of the advertised codecs are enabled in the Mipt service.

IN-14654

DGW-12720 An audible humming sound is present after a flash hook. FXO

There is no longer noise on FXO ports when receiving a SIP flash relay.

IN-14504

DGW-12277 The Caller ID is not always detected on FXO ports. FXO

The Caller ID was not detected on FXO ports because it needed power normalisation. The FSK Caller ID signal strength for incoming calls on FXO ports can now be configured with the new Pots.FxoInteropNormalizeFskCallerId parameter. This new parameter is not available in the DGW Web interface.

IN-14430

DGW-11927 When using TR-069, the Mediatrix unit is sending the POST without SOAP-ENV:Header and the cwmp-ID. TR-069

The unit is now sending the POST with an SOAP-ENV:Header containing a cwmp-ID.

Cookie parameters in POST are now properly separated. The "CharCode" parameter has also been removed.

Top

4 Known Issues

Incident # CR # Synopsis Applies To
Top

5 Copyright Notice

Copyright © 2020 Media5 Corporation.

This document contains information that is proprietary to Media5 Corporation.

Media5 Corporation reserves all rights to this document as well as to the Intellectual Property of the document and the technology and know-how that it includes and represents.

This publication cannot be reproduced, neither in whole nor in part, in any form whatsoever, without written prior approval by Media5 Corporation.

Media5 Corporation reserves the right to revise this publication and make changes at any time and without the obligation to notify any person and/or entity of such revisions and/or changes.

Top